EnergyFit Visalia Insulation Solutions insulates attics, walls and crawl spaces in Lindsay, CA. We seal air leaks first and clear out spoiled old insulation, so rooms that run hot upstairs or cold underfoot finally stay comfortable.
Lindsay is a short drive from Visalia, and most of our calls here come from older single-story houses on quiet residential streets. There are some newer homes toward the edges of the city and a handful of shops and offices downtown. They're a lot like the houses we see over in Exeter. They've been lived in a long time, so years of stored boxes, wiring and patched-in ductwork usually sit between the attic hatch and the eaves. I learned this trade on new houses with every wall open, and these lived-in homes are the harder, slower work I started this business to do.
A lot of these houses sit on raised floors over a crawl space, so cold floors usually trace back to what's underneath. Up top, the attics tend to be low, and the old insulation has often settled thin or gotten dirty, so we often have to clear it out and seal the gaps before anything new goes in.
Spray foam fits rooflines and tight spots where loose fill won't stay put. We plan around the time you'll need to be out of the house before we start.
Explore serviceMost Lindsay calls start in the attic, where I measure how many inches are already up there. Then we seal the gaps and bring the coverage up evenly, all the way to the eaves.
Explore serviceBlown-in insulation is loose fill blown through a hose, and it's how we top up most older attics here. We keep it off the eave vents so the attic still breathes.
Explore serviceWhen several rooms won't stay comfortable, I look at the attic, walls and floor together. Then I tell you which one to fix first.
Explore serviceOld insulation that's been soaked or is full of droppings comes out before anything new goes in. Covering it just keeps the problem in your house.
Explore serviceHouses on raised floors often have cold floors because the insulation underneath is missing or sagging. We refit it snug against the underside of the floor.
Explore serviceOlder walls here are often empty or thinly filled. We insulate them through small openings, so your plaster or drywall stays in place.
Explore serviceAir sealing means closing the gaps before we insulate, around pipes, wiring holes and the hatch. That way your new insulation isn't fighting a draft.
Explore serviceFew Lindsay homes have a basement. Where one exists, we insulate the walls and rim in a way that handles the moisture down there.
Explore serviceClosed-cell foam is a dense foam that also blocks moisture. It's what I'd suggest for a damp crawl space or a spot where moisture keeps coming through.
Explore serviceOpen-cell foam is softer and lighter. It suits an attic roofline when the ductwork lives up there and you want that space kept closer to room temperature.
Explore serviceFor shops and offices in Lindsay, we plan the insulation around tenants and the other trades on the job, so our work doesn't hold up theirs.
Explore serviceA vapor barrier laid over a bare dirt crawl space keeps ground moisture away from the wood and the insulation above it.
Explore serviceWe install vapor barriers in walls, floors and ceilings that need moisture kept on one side. Before anything goes up, we check which side that is.
Explore serviceIn the attic, we seal the leaks around can lights, the hatch and the tops of the walls. It's the step that usually gets skipped, and it's the one that matters most.
Explore serviceRetrofit work means adding insulation to a house you already live in, working around the wiring, ducts and stored boxes. It's slower than new construction, and we take the time to do it right.
Explore serviceInsulation work in Lindsay falls under California's contractor licensing rule, so look up any contractor with the state licensing board before you sign. We're licensed and insured. Before work starts, we check with the office that covers your address on whether your job needs a permit. If it does, we apply for it as your licensed contractor and meet the inspector on site, and that step comes before our start date.
The City of Lindsay is the local government for addresses inside the city, and we're out this way often between Visalia and jobs in Woodlake. The price depends on how much old material has to come out, how many gaps need sealing, how hard the attic or crawl space is to reach, and whether you choose foam or loose fill. Foam costs more and seals air as it goes on. On most houses here, though, I'd rather seal the gaps and top up with loose fill, unless your ductwork runs through the attic. The schedule depends on those same things plus any permit, and your written estimate, with photos of what I found, lays out both for your house.
Tell us what's going on, whether it's a hot room upstairs, cold floors or a power bill that keeps climbing, and we'll reply within one business day to set a time. I come out myself for a free on-site estimate, look through the attic or crawl space, and give it to you in writing with photos of what I found. There's no obligation, so you can take your time and decide.
(559) 409-1169Yes. A license is required if the job needs a building permit, uses any extra workers, or costs $1,000 or more in labor and materials across one or more contracts, which usually covers an attic or crawl space job. Contractors also have to be licensed before they submit a bid, so you can look them up with the Contractors State License Board before you compare estimates.
No. The state board doesn't allow a larger project to be broken into pieces under $1,000 to get around the license rule, and for a homeowner, the cost of the whole project is what counts. The small-job exemption applies only when the total stays under $1,000, the work needs no building permit, no employees are used, and the person doesn't advertise as a licensed contractor.
The City of Lindsay posts its code at lindsay.municipalcodeonline.com. The online version is there for information and convenience only, so if it ever differs from the official hard copy, the hard copy governs. The contact listed on that page is 559-562-7102 at 251 E. Honolulu St.
Usually not for blown-in work, though it's best to keep kids and pets away from the hatch while the crew is going in and out. Spray foam is different. You'll be out of the house until the re-entry time, when it's safe to come back inside, and I'll go over that with you at the estimate so you can plan.
We're an insulation contractor based in Visalia, CA, and we work across the cities around it, from Kingsburg and Selma to Hanford, Lemoore and Woodlake. The cities listed here have their own pages. If yours isn't one of them, call and ask.
We answer (559) 409-1169 until 9 PM every day of the week, so you don't have to take time off to set up a visit.
If something in your attic or crawl space doesn't look right, send us a note, and I'll come out to Lindsay and take a look before anyone talks price.
Tell us about your project
